Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
6.2

Parameter Setting

1.
Press and hold the SET button for at least 3 seconds until [— — —] flashes on the
display. Use the ▲ button to enter the factory password [010] and press the SET
button to enter the setup menu. An incorrect password will return the station to
normal operation mode (temperature indication). The display shows [F-0].
2.
Press the ▲ or ▼ button to select a mode. If you do not press a button within
15 seconds, the station returns to normal operation mode.
F-0: exit menu mode
Press the SET button when the display shows F-0 to exit the setup menu and return to
normal operation mode.
F-1: password mode
If the password mode is enabled, you cannot change the temperature and airflow
settings on the station unless you know the password.
Press the SET button once to enter the password mode. Press the ▲ or ▼ button to
switch between [000] (password mode disabled) and [100] (password enabled). Press
the SET button to return to the setup menu.
F-2: temperature unit
Press the SET button once to enter temperature mode. Press the ▲ or ▼ button to
switch between [°C] and [°F]. Press the SET button to return to the setup menu.
6.3
Auto Sleep Mode
When the soldering iron is placed in its holder, the switched-on station automatically
lowers the iron temperature after 20 minutes of inactivity (sleep mode). As soon as you
pick up the iron, the station exits the sleep mode.
6.4
Switching Off the Station
After use, place the iron in its holder and switch off the station.
After switching off, leave the power cord plugged in for a few minutes. When you switch
off the unit, the automatic cooling function blows cooling air through the heater pipe for
a short period. This protects the heater from damage and extends its lifetime. Do not
disconnect the mains plug during this cooling process.
Wait until the cooling process has stopped, then disconnect the power plug. The device
uses a small amount of electrical power, even if it is switched off.
V. 01 – 16/03/2018
VTSSD5
6
©Velleman nv

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis