Sony FWD-S42E1 Bedienungsanleitung Seite 71

Automatically obtaining an IP address
1
Press MENU button to bring up the main
menu.
2
Select "Setup" with F/f buttons and press
button.
3
Select "Advanced Setup" with F/f buttons
and press button.
4
Select "IP Address Setup" with F/f
buttons and press
5
Select "DHCP" with F/f buttons and press
button.
Select "Execute" and press
is automatically set.
When "Cancel" is selected, the setting will not be
executed.
Note
When an IP address is not set properly, the following error
codes will be displayed in accordance with the error cause.
Error 1: Communication error between the display and the
optional adaptor such as the BKM-FW32/FW50/FW55
Error 2: The specified IP address is already used for other
equipment
Error 3: IP address error
Error 4: Gateway address error
Error 5: Primary DNS address error
Error 6: Secondary DNS address error
Error 7: Subnet mask error
Error 8: Player IP Address error (When installing optional
adaptor BKM-FW55.)
Checking the automatically assigned IP
address
1
Press MENU button to bring up the main
menu.
2
Select "Setup" with F/f buttons and press
button.
3
Select "Information" with F/f buttons and
press button.
The IP address currently acquired is displayed.
Tip
When an IP address cannot be acquired properly, the
previously acquired IP address is shown in "Information"
and in "Manual" of "IP Address Setup".
button.
button. An IP address
Setting a communication speed
1
Press MENU button to bring up the main
menu.
2
Select "Setup" with F/f buttons and press
button.
3
Select "Advanced Setup" with F/f buttons
and press button.
4
Select "Speed Setup" with F/f buttons and
press button.
5
Select a desired communication speed to
set from "Auto", "10Mbps Half", "10Mbps
Full", "100Mbps Half", or "100Mbps Full"
with F/f buttons and press
When "Auto" is selected, a communication speed
appropriate for your network configuration is
automatically set.
6
Select "Execute" with F/f buttons and
press button to reflect the setting.
button.
GB
31
GB