Sony FWD-S42E1 Bedienungsanleitung Seite 67

Menu
Display Only
Remote Only
Auto Screen Adjust
Auto Shut Off
Overscan
Auto
On
Off
Sync Mode
H/Comp
Video
RGB/YUV
Display/Option
Auto
RGB
YUV
Function and operation
Enables operation of the display with the control buttons on the display. You can
only use buttons on the display to enter this setting.
Enables operation of the display with the remote control. You can only use the
remote control to enter this setting.
Select "On" or "Off". If you select "On", it saves settings such as picture size and
position for each input signal, and the last settings are automatically applied.
Note
The "Auto Screen Adjust" function only works during RGB input.
Select "On" or "Off". If you select "On", the display automatically goes into power
saving mode when no signal is input to the DVI, HD15 (RGB/Component), BKM-
FW11 or BKM-FW15 input connectors for more than about 30 seconds.
Tips
• While in the standby mode, press the 1 button on the display or the
on the remote control to turn the display on. In the power saving mode, the
display is turned on automatically when a signal is input.
• This function is not available when "On-Screen Logo" is set to "On", the
screensaver function is activated.
Selects whether to display images with overscan or justscan.
Automatically determines whether it is a DTV signal, then overscans and displays
the image.
Displays image with overscan.
Displays image with justscan.
Note
During DTV signal input, it may display a screen like when a PC signal is input.
Example: 480P → 720 × 480/60
Set the type of signal input at pin 13 of the HD15 (RGB/COMPONENT) IN
connector.
Notes
• "Sync Mode" is available only when analog RGB signal is input to HD15
connector.
• There are some inputs for which only "H/Comp" can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the
connectors.
• Sync Mode settings cannot be carried out for the input through the optional
adaptors.
• This display does not support the three value sync format of 576/60p.
• When "Video" is selected in "Sync Mode", you can only set the 575/50i and 480/
60i signals.
Sets a horizontal synchronous signal input.
Sets a video signal input.
Sets the type of signal for a video device or PC connected to the HD15 (RGB/
COMPONENT) connector of the display or the BNC (RGB/COMPONENT)
connector of an optional adaptor.
For setting a signal on the display's HD15 connector, select "Display". For setting
a signal on the Option Adaptor, select "Option".
Automatically sets an analog RGB signal or a component signal inputted from a
connected equipment.
Sets an analog RGB signal inputted from a connected equipment.
Sets a component signal inputted from a connected equipment.
ON button
GB
27
GB