Sophos XRP 200 Montageanleitung Seite 3

External Redundant Power Supply Mounting Instructions
Step 3
Connect the DC power cable between the
External redundant power supply and the
DC connector located at the back side of the
appliance.
Step 4
Plug an AC power cable to the External redundant
power supply and turn it ON.
The LED against label "Ext." on the front side
of your appliance should turn green, indicating
that the External DC redundant Power supply is
working properly.
If the LED is red, then the connected External
redundant Power supply is defective.
If the LED is OFF, then the External redundant
power supply is not connected.
* For more information and technical support please visit
XRP 200
3.
*
4.
www.sophos.com/en-us/support
4