Sennheiser Surrounder series Gebrauchsanleitung Seite 21

DSP PRO DOLBY PROLOGIC DECODER
The following describes the connection of the Surrounder Pro to a stereo sound source such
as a video recorder, a satellite receiver, a CD player, or a stereo soundcard.The Dolby
stereo sound signal is decoded via the DSP Pro.
• Connect the jack plug labelled "F" to the left socket (L R) at the front of the DSP Pro
decoder.
• Use the supplied 3.5/3.5 mm jack plug adaptor
to the right socket (C S) at the front of the DSP Pro decoder. The adaptor suppresses
the signal for the centre channel and distributes the surround signal to the rear speakers.
(Connect the DSP Pro decoder to the sound source. If the sound source features a
3.5 mm jack socket, use the adaptor cable
• Press the "POWER" button of the DSP Pro decoder.
• Press the button with the headphone symbol until the LED goes off.
• Press the "PHANTOM" button, the centre channel is now distributed to the two front
channels. The LED next to the button lights up.
Connection to a sound source via the DSP Pro
The illustration below shows how to connect the Surrounder Pro to a stereo soundcard
featuring a 3.5 mm stereo jack socket.
Connection to a stereo soundcard via the DSP Pro
NT 12
L,R DSP Pro
Adapter C,S
NT 12
L,R DSP Pro
Adapter C,S
to connect the jack plug labelled "R"
).
NT DSP Pro
NT DSP Pro
Soundcard
Stereo Out
2 1