Quasar 6 Control Panel; Initial Startup; Power Supply; Inserting The Rechargeable Battery - Nedo Quasar 6 Bedienungsanleitung

4 Structure

Quasar 6 control panel

4.2
1
Switches the Pulse function
2
Consecutively switches the
3
Press 1 x: V
Press 2 x: V
Press 3 x: V
Press 4 x: all off
4 Switches the horizontal
beam on / off.
Lights up red if power supply
5
Lights up red if inadequate.
5

Initial Startup

Quasar 6
When starting the Quasar 6 up for the first time, charge the integrated set of rechargeable
batteries (4.8V / 2x2.4V) to become maximum operating time. Use the charger supplied
(see chapter 6.2).
Important! Only use the charger supplied.
6

Power Supply

6.1 Insert rechargeable batteries
The Quasar 6 green requires 2 NiMH rechargeable battery
packs.
• Push together the tabs to the right and left on the battery com-
partment cover.
• Pull off battery compartment.
• Insert rechargeable battery packs as specified.
Ensure pole direction is correct!
• Position battery compartment and push into the unit.
• Ensure that both tabs latch into place.
Quasar 6 Operating Instructions
"Pulse function"
button
on / off
LED display
"Pulse function"
Lights up green if "Puls
function" mode activated.
"Vertical" button
four vertical beams on and
switches them all off
together (see chapter 3.1).
+V
1 2
+V +V
1 2 3
+V +V +V
1 2 3
4
"Horizontal" button
LED display
"Rechargeable battery"
is weak.
Power supply.
(See figure)
2
1
4
3
5
-
-
EN
4
17