Daily Use; Setting And Starting A Programme - Electrolux GA556IFWE Benutzerinformation

14 www.electrolux.com
Fill the rinse aid dispenser
when the indicator (A)
becomes clear.

9. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
B
C
If you use multi-tablets and
the drying performance is
satisfactory, the rinse aid refill
indication can be disabled.
We recommend to always
use rinse aid for better drying
performance, also in
combination with multi-
tablets containing rinsing
agent.
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode and door is closed.
2. Press Program again and again until
the indicator of the programme you
want to select comes on.
The display shows the programme
duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running phase
comes on.
• The programme duration starts to
decrease with steps of 1 minute.