TRILUX LMS HFS RMC Bedienungsanleitung Seite 25

* teach-in mode
The teach-in mode enables saving a currently
active daylight situation as the light threshold
value.
To start the teach-in mode, press and hold the
-LUX- function button for five seconds.
Following this the sensor measures the cur-
rent lighting level for 20 seconds and saves
this is a threshold value under configuration 5.
During the measurement process the red con-
trol LED of the luminaire flashes at two second
intervals.
At the end of the 20 second measurement, the
luminaire flashes for 2-3 seconds in rapid suc-
cession as a confirmation that the system is
again ready for operation.
48
** DIM-value 0 %
If configuration button 1 is selected (DIM
value = 0%), then the -permanent mode- pro-
gram mode (see also page 52) is automati-
cally specified.
Information basic setting
For each basic setting and during a 10 second
interval, a different level can be selected
at any time by pressing another configura-
tion button in order to set various functional
levels.
The 10 second setting interval becomes valid
again after each press of the configurations
button.
49