Operation - Ayce PLD2233 Originalbetriebsanleitung

OPERATION

1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
Attaching a nozzle (Fig. 1)
Failure to unplug the tool could result in accidental starting causing
!
possible serious personal injury.
WARNING
Fig. 1
Removing the heat protection collar (Fig. 2)
Fig. 2
MNL_hot air gun_(DE-FR-IT-GB)_2014-0806.indd 56-57
• Ensure that the heat gun is switched
off and disconnected from the supply,
and allowed to cool down before
changing a nozzle.
• Fit one of the four nozzles onto the heat
nozzle by inserting it on the heat nozzle
simply.
Note: Do not apply the nozzle too close to
the work piece being worked. The hot air
build-up can lead to overheating of the
appliance.
The heat protection collar can be removed
when working at particularly hard-to-
reach locations.
!
Be careful of the hot nozzle! Increased danger of burning exists when
working without the heat protection collar.
WARNING
To remove or mount the heat protection collar, switch the appliance off and allow it
to cool down. To speed up the cooling, the appliance can also be operated for a short
period with the lowest adjustable temperature.
Pull the collar outwards to remove it.
Setting the temperature (Fig. 3)
• The temperature can be increased and
Fig. 3
• Either tap the buttons briefly or press
Decrease the
temperature
Increase the
• When doing this please note the
temperature
!
Do not drop the device - the ceramic heating element that is located
inside the device is particularly sensitive to shock and impact.
WARNING
56 | 57 GB
decreased in intervals of 10 °C via the
control panel. To increase the
temperature press the left-hand
button (+); to decrease the temperature
press the right-hand button (-).
and hold the buttons until the desired
temperature setting is reached.
maximum temperature, which
depends on the on/off switch. The
maximum temperature is only possible
in switching to stage 2. If switching
to stage 1 is selected, the maximum
temperature is 50 °C and the
temperature cannot be adjusted. The
setting you have selected can be read
on the LCD display.
2014/8/8 15:14:17