Ayce 1314 Betriebsanleitung Seite 78

b. Installing parallel guide (Fig.2)
Fig. 2
c. Adjusting the depth cut (Fig.3)
The depth of cut is the distance between the depth stop and the depth stop turret.
!
Unplug the router before adjusting the depth stop.
WARNING
Fig. 3
1. The parallel guide is an effective aid
to cutting in a straight line when
chamfering or grooving.
2. Loosen two screws for parallel guide.
3. Feed the bars on the parallel guide
through the holes in the base plate.
4. Adjust the distance between the
router bit and the parallel guide by
moving the guide until it is at the
correct distance.
5. Tighten the screws for parallel guide
to hold the parallel guide in position.
1. Loosen the locking screw so that
depth stop can be moved freely.
2. Push down the plunge lock lever
anti-clockwise and plunge the
router down until the router bit
touches the work-piece, then lock
the router in position by releasing
the plunge lock lever.
3. Move the depth stop down against
the turret depth stop and record the
scale, set to "0".
4. Adjust the depth stop to the
required routing depth, push down
the plunge lock lever anti-clockwise
and guide the router back up again.
The coarse adjustment of the depth-of-
cut should be checked by a trial cut and
corrected, if necessary.