Traxon Butler S2 Installationhandbuch Seite 19

Versions
Hardware Build Version
Software Build Version
Cluster Mode
Cluster ID
Cluster Size
Device Mode
Advanced Setup
Lock Settings
BRK Length
MAB Length
BRK Length RDM
MAB Length RDM
RDM Switch Time
BRK Length
MAB Length
Do not modify the Advanced Settings, if you are not fully aware of the results.
Close the Network Configuration Dialogue, the changes will be transferred to the
Butler S2. You can now integrate the Butler S2 to the Programmer for DMX output
or show upload.
Execute the Device Manager dialogue of the Programmer by clicking the smart-
phone symbol in the top menu.
The hardware version (read only).
The software version (read only).
Generated ID of the cluster for master/slave mode.
Number of engines in this cluster.
Master or Slave n/m (n of m).
Checkmark, set by default, avoids changes for DMX
and RDM by chance.
Break signal length in µs for the DMX protocol.
Mark after break length in µs for the DMX protocol.
Break length in µs for the RDM protocol.
Mark after break length in µs for the RDM protocol.
The RDM Tx to Rx length in in µs.
Break length for e:pix protocol (not used).
Mark after break length for e:pix protocol (not used).
Setup Manual - Butler S2
19