Network Parameters - Traxon Butler S2 Installationhandbuch

Setup Manual - Butler S2
Set the necessary parameters for the Butler S2. The factory settings for the IP
address is 192.168.123.1, be sure that no other device in the network uses this IP
address.
When setting up more then one Butler S2 with factory settings, con-
nect only one to the network, set a new IP address, then connect and
configure the next Butler S2.

Network parameters

Device Basics
Device Name
IP address
Subnet Mask
Gateway address
MAC address
18
The device will be displayed with this name in the e:cue
programmer.
The IP address of the device (default: 192.168.123.1)
The netmask of the device (Default: 255.255.255.0)
The default gateway of the device (Default: no gateway)
The physical address of the device (read only)