Programming And Deleting The Run Times - Becker MC415 Montageanleitung Und Betriebsanleitung

Programming and deleting the run times

First select the desired channel using the channel selection
button.
Programming the run times
1. If necessary, run the roller shutter or blind to the opposite limit position.
2. Wait until the time at which the automatic run command is to be carried
out.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. Now release the direction button.
The receiver has saved the current time for this direction of travel. Proceed in
exactly the same way with the other direction of movement. Automatic run
commands are not carried out for the selected channel in the " " operating
mode. The saved run times are retained.
Deleting the run times
Deleting always removes both the run times for the selected
channel.
To delete the UP and DOWN run time, press the STOP button for 10 seconds.
Acknowledgement is given by a "click click" from the drive, or by a "shift" of
the shading solution.
The run times are now deleted.
18 - en