Troubleshooting - Braun Series 9 Gebrauchsanweisung

Trouble-Shooting
Problem:
Shaver does not start
when pressing the
start button.
Shaver does not
charge completely
and keeps blinking.
Charging does not
start when connected
to power socket.
Unpleasant smell
from the shaver head.
Battery performance
dropped significantly.
Shaving performance
dropped significantly.
Shaver turns off with
fully charged battery.
Possible reason:
1. Travel lock is activated.
2. This appliance can only be
operated cordless.
Ambient temperature is out of
valid range.
1. Sometimes charging could
start delayed (e.g. after long
storage).
2. Ambient temperature is out
of valid range.
3. Special cord set is not
plugged in properly.
Shaver head is cleaned with
water.
1. Shaver head is regularly
cleaned with water but not
lubricated.
2. Foil and cutter are worn
which requires more power
for each shave.
1. Shaving system is clogged.
2. Foil and cutter are worn.
Foil and cutter are worn which
requires more power than
the motor can deliver. The
appliance turns off.
Remedy:
1. Press the on/off switch for 3 seconds to unlock
the shaver.
2. Unplug the shaver.
Recommended ambient temperature for charging is
5 °C to 35 °C.
1. Wait a few minutes, if charging will start auto-
matically.
2. Recommended ambient temperature for charging
is 5 °C to 35 °C.
3. Special cord set needs to snap into place.
When cleaning the shaver head with water only use
hot water and from time to time some liquid soap
(without abrasive substances). Remove Foil &
Cutter cassette to let it dry.
1. If the shaver is regularly cleaned with water, apply
a drop of light machine oil on top of the foil once
a week for lubrication.
2. Replace Foil & Cutter cassette.
1. Soak the Foil & Cutter cassette in hot water with
a drop of dish liquid. Afterwards rinse it properly
and tap it out. Once dry apply a drop of light
machine oil on the foil.
2. Replace Foil & Cutter cassette.
– Replace Foil & Cutter cassette.
– Regularly oil the shaving system, especially when
cleaning with water only.
11