Jydepejsen DIC Blue Bedienungsanleitung Seite 15

Omega Chef
The temperature sensor in Omega Chef is situated in the rear part of the stove module. This NECESSITATES
dismantling the temperature sensor before sweeping the chimney as you otherwise risk damaging the sensor during
sweeping.
1. Remove the top plate.
2. Loosen the nut.
3. Remove the reflector panel.
4. Lift the side panel for dismantling.
5. Dismantle the screw.
6. Carefully pull out the holder and the temperature sensor.
7. (Loosen the set screw if the temperature sensor needs replacement.)
8. Remember to set the distance from the top of the temperature sensor to the top end of the holder at 45
mm.
9. Put the stove back together in reverse order after sweeping.