Jydepejsen DIC Blue Bedienungsanleitung Seite 13

Rear flue modification
Dismantling
1. Remove the top plate.
2. Dismantle (a).
3. Dismantle the holder (c) with the
temperature sensor (d).
4. Dismantle (e) and (f). When dismantling
(e), put your hand down through the flue
pipe to keep the nut on the inner side in
place.
Reinstallation
1. Fit back (e) with the removed nut (h).
2. Fit back (a) into the threaded hole.
3. Fit back the holder (c) with the
temperature sensor (d).
4. Tighten (f)
Height of temperature sensor
Make sure that there is a distance of 55 mm
from the top of the temperature sensor (d) to the
top end of the holder (c).
If the temperature sensor is not at the correct height,
you can adjust it by loosening the set screw (g).