Jydepejsen DIC Blue Bedienungsanleitung Seite 14

Replacement/dismantling of temperature sensor
If the chimney is swept from below, it is very important to dismantle the temperature sensor before
sweeping as the temperature sensor can otherwise be damaged.
Dismantling of sensor
1. Remove the top plate.
2. Loosen the set screw (g).
3. Pull out the temperature sensor (d) carefully.
4. Put the stove back together in reverse order after sweeping.
5. The rear flue temperature sensor is dismantled in the same way.
Height of temperature sensor
Make sure that there is a distance of 55 mm
from the top of the temperature sensor (d) to the
top end of the holder (c).
If the temperature sensor is not at the correct height,
you can adjust it by loosening the set screw (g).