Programming - Busch-Jaeger 6136/100CB-102 Bedienungsanleitung

9.2

Programming

Call up "Commissioning" in the "System"
menu.
● See chapter "System settings".
● You may now program the unit using an
SD-/MMC card or via the bus.
Programming via the bus may take several hours, depending on the configuration. Use bus
progamming only for minor project changes!
We recommend programming with an SD/MMC card!
Programm- 1. Create the new project with the
ing with commissioning software on a PC and save
SD/MMC the project on an SD/MMC card.
card
2. Insert the SD card into the room/control
panel and press the "Read Multimedia/SD
card" button (Fig. 69).
ENG
Fig. 67
Fig. 68
43