Replacing The Fuse; Inserting/Replacing The Battery; Technical Specifications - Dimavery BA-15 Bedienungsanleitung

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the battery. Maintenance and service operations
are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts. Should you have further questions, please
contact your dealer.

5.1 Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure for BA-15 and BA-30:
Step 1: Unscrew the fuseholder on the rear panel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Procedure for BA-60:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.

5.2 Inserting/Replacing the battery

Open the battery cover and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct. Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.

6. TECHNICAL SPECIFICATIONS

Article:
Power supply:
Power consumption:
Power output sine:
Speaker:
Input sensitivity:
Frequency range:
S/N ratio:
Connectors:
Fuse:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 07.07.2011 ©
Caution!
Danger of explosion when batteries are replaced improperly.
BA-15
230 V AC, 50 Hz ~
30 W
15 W RMS/ 8 Ohm
15,24 cm (6")
20 mV
20 Hz - 15 kHz
>70 dB
6.3 mm jacks
F 0.5 A, 250 V
340 x 330 x 225 mm
7.5 kg
BA-30
230 V AC, 50 Hz ~
60 W
30 W RMS/ 8 Ohm
20,32 cm (8")
20 mV
20 Hz - 15 kHz
>70 dB
6.3 mm jacks
F 0.5 A, 250 V
390 x 380 x 230 mm
9.5 kg
20/20
BA-60
230 V AC, 50 Hz ~
100 W
60 W RMS/ 8 Ohm
30,48 cm (12")
20 mV
20 Hz - 15 kHz
>70 dB
6.3 mm jacks
F 2 A, 250 V
480 x 500 x 450 mm
23 kg
00046229.DOC, Version 1.1