Replacing The Fuse; Technical Specifications - Dimavery TGA-50 R Bedienungsanleitung

5.1 Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.

6. TECHNICAL SPECIFICATIONS

Power supply:
Maximum Power:
Input impedance:
Frequency range:
Speaker:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 14.11.2006 ©
TGA-50R
230 V AC, 50 Hz~
50 W
20 mV
100 Hz - 8 kHz
12"
720 x 570 x 300 mm
29 kg
20/20
26362050_V_1_0.DOC