Installation; Connecting The Appliance To The Mains - Icematic E serie Serviceanleitung

1. INSTALLATION

Implement the following operations before activating the
ice maker:
1. Verify that the ice maker has not been damaged during
q
transport (fig. ).
2. remove all the material provided from the container: supply
pipe, drain pipe, documentation and any accessories.
3. Clean inside the container with a sponge dampened with
warm water and a little sodium bicarbonate; rinse with clean
water and dry carefully.
4. Place the ice maker in its definite location and ensure that it
a
is perfectly level (fig.
i
Note: When choosing where to install the appliance, make sure
that:
• the room temperature never drops below 10°C (50°F) and does
not exceed 43°C (110° F).
• the water temperature must be no less than 10°C (50°F) and no
more than 32°C (90°F) (fig.
• the supply water pressure must be no less than 0,1 MPa (1 bar)
and no more than 0,5 MPa (5 bar).
Should the pressure exceed 0,5 MPa, install a pressure reducer on
the machine water supply (fig.
• d) the machine is away from heat sources and in a well-venti-
o
lated area (fig. ).
Connect only to the drinking water mains
5. use the new set of mobile junctions (water pipe) supplied
with the appliance. the old set of junctions must not be
reused.
6. Install the water connections before the electrical connec-
tions.
7. Connect the 3/4''supply pipe (supplied) to the machine and
to the cold drinking water supply line.
For practical and safety purposes, it is advisable to install a
shut-off valve (not supplied by Castelmac) (fig.
2. socket; 3. electrical plug; 4. water supply; 5. valve; 6. water
drain from the condenser: water-cooled version; 7. water
drain from the container; 8. water drain with open siphon).
8. apply the flexible pipe (supplied) with a 20 mm inner diam-
eter and of adequate length (not more than 1 metre from
the machine) to the water drain fitting of the machine in
order to reach the drain well (fig.
12
).
u
).
i
).
h
: 1. switch;
h
).
i
Note: Install the machine in a position that the ventilation of the
cooling unit is not obstructed in any way (only for air-cooled ma-
s
chines) (fig.
• Do not install the machine in a dusty room as the condenser of
the cooling unit can be easily clogged (only for air-cooled ma-
2)
chines) (fig.
• If the machine is installed in an area where the drinking water
has a high content of salt solutions, follow the manufacturer's
instructions in order to minimise the problem.
• To prevent the ice from absorbing bad smells and tastes, never
store food, bottles, etc. in the container.
• Do not leave the ice container door open during normal opera-
tion.
There must be a differential switch (cut-out) in the electri-
cal system.

1.1. CONNECTING THE APPLIANCE TO THE MAINS

• If the power supply cable is damaged, it must be replaced
by qualified personnel to prevent any hazards to persons
71503816/0 - rEV.02
).
).
10/2011