dirna Bergstrom Bycool Slim Fit MAN Montageanweisungen Seite 18

SLIMFIT
EN
1- Run the power supply cable from the unit through to the vehicle battery, attaching the plastic mounts to
the rear of the cabin and securing with flanges; then, with the cabin tilted, pass the cable through the
bottom, securing it with clamps and M4 screws; and through to the battery with flanges; use the original
cabling run. (Clean the area thoroughly before attaching the plastic mounts). When the equipment is
connected to the battery, this will carry out a test of all the LEDs, displaying 88--SC and then going off.
! IMPORTANT: Due to the complex system of electronic regulation of the equipment, the
current connection must be made directly to the vehicle battery, and not to any other point
which services other accessories of the vehicle, taking care not to invert the polarity when
making the connection (2).
! IMPORTANT: Please consult User's Guide before starting.
Detailed instructions
on power wiring assembly
1
2
+
18
Air conditioning for vehicles
Wiring
supply
2
-