Junghans Essential Bedienungsanleitung Seite 8

Restart after replacement of the battery:
The LCD shows 'H', through compensator (left) the hour and minu-
te hands must be set to exact position and the positioning must be
finished through corrector 2 (right) analogously to function
'Positioning of the hands'. The LCD shows 'S', through corrector 1
(left) the second-sweep-hand must be set to exact position and the
positioning must be finished through corrector 2 (right) analogously
to function 'Positioning of the hands'.
If the reception is sufficient, all further functions are performed
automatically as described in section 'Transmitter call' and after few
minutes your watch shows correct time and date information. In
case of inferior reception, or locations absolutely outside of range of
transmitter, your watch will not be able to establish the reception
and you will not see any time information. In such a case the spe-
cial software permits also a manual start of your watch, which you
please perform as follows.
Manual start mode:
After finished positioning (Note positioning of the hands) actuate the
corrector 2 (right) for more than 3 seconds. Now actuate the corrector
1 (left) shortly, the LCD shows the minute. Upon repeated conti-
nuous or single actuation of the corrector 1 (left) the LCD minute
display and the hands move fast or in single steps. This way, set the
correct time according to other clock / watch. The last exact setting
of the minute should be made precisely at the top of the minute.
Thus the time is synchronized with precision to the second with the
14
other clock / watch. Close the manual start with short actuation of
the corrector 2 (right). Manual start is indicated on the LCD display
by permanent "1" beside the display of the seconds. The transmit-
ter tower is invisible. In the manual start mode your watch attempts
to automatically receive the radio-controlled time at each top of the
hour. The transmitter call is also possible, should, however, be
activated only within the range of transmitter. After a successful
reception your watch displays radio-controlled time automatically.
Automatic functions of your watch:
– Synchronization to the second
During the night at 2:00, 3:00 and if necessary at 4:00, 5:00 and
6:00 o'clock the receiver is turned on and the internal time is syn-
chronized via radio to the second. Should none of the attempts to
synchronize the time during the night be successful, the control of
reception would be increased by "1". The days of non-reception are
cumulated. During these days your watch works still very accurate-
ly on the quartz-time basis with the help of internal time memory.
Upon the next possible successful reception the synchronization is
performed and the control of reception is reset to "0".
– Adjustment of daylight saving to standard time and vice versa
In case of reception without interference, the time of your watch is
adjusted automatically during the night at 2:00 or 3:00 o'clock.
Interference may delay the adjustment until early morning hours.
– Battery replacement indication
15