Junghans Essential Bedienungsanleitung Seite 7

Transmitter call:
Actuate the corrector 2 (right) for more than 3 seconds. The hands of
your watch move fast to 12:00 o'clock position and in normal case
remain exactly in this position. Should this position not be reached
exactly, please continue according to following instructions
'Positioning of the hands' first. In case of immediate exact position of
the hands hold the watch still (best of all take it from the wrist and
lay it on a flat surface: no metal surface) to establish a secure
connection - transmitter tower is blinking - the LCD seconds display
starts counting. After few minutes your watch sets all current time
information automatically and the transmitter call is finished. To
stop the transmitter call before the function is completed, actuate
the button (right) shortly. After that the stored time values will be dis-
played.
Note "Positioning of the hands":
The exact 12:00 o'clock position has not been reached. Actuate the
corrector 1 (left) now. The LCD shows 'H' (zero position of hours and
minutes hands). In this position your watch prompts you to set the
hands to the exact 12:00 o'clock position through further actuation
of the corrector 1 (left). Permanent pressure starts a continuous fast
movement of the hands, single actuation results in individual steps.
As soon as the correct position has been reached, finish the posi-
tioning through a short actuation of the corrector 1 (left).
The LCD shows 'S' (zero position of the second-sweep-hand).
12
In this position your watch prompts you to set the second-sweep-
hand to the exact 12:00 o'clock position through further actuation
of the corrector 1 (left).
Permanent pressure starts a continuous fast movement of the
hands, single actuation results in individual steps. As soon as the
correct position has been reached, finish the positioning through a
short actuation of the corrector 1 (left). Switching between the set-
tings of the hours/minutes hands 'H' and second-sweep-hand 'S' is
possible as many times as you like. As soon as the correct position
has been reached, finish the positioning through actuation of the cor-
rector 2 (right) for more than 3 seconds or if you do not do anything
for 9 seconds, the watch switches to DCF reception mode. Display:
Transmitter tower is blinking.
Note to operating errors:
If you inadvertently actuate both control elements simultaneously
for more than 3 seconds, a microprocessor in your watch performs
a hardware reset; all saved time information is lost. In this case fol-
low the instructions for restart of your watch after replacement of
the battery.
Replacement of the battery:
It is recommended to have the battery replaced by specialized retail
shop or by customer service.
13