Junghans Essential Bedienungsanleitung Seite 6

GB
Dear Custumer,
With purchase of this radio-controlled watch you are in possession
of chronometer equipped with the latest technology, allowing mani-
pulation with the help of two correctors. The supplementary function
"Manual start" now guarantees also the possibility to replace the
battery out of the range of transmitter.
For this please keep your operating manual always within reach at a
safe place.
General information:
Hours and minutes on your watch are displayed analogously by
means of the hand and seconds by the second-sweep-hand, the cur-
rent date is shown digitally on the LCD.
Change of LCD information display:
Pressing the corrector 2 (right button) for a short time (< 3 seconds)
switches from display of the date (day/month) to display of seconds
and signal reception. Permanent display of the radio tower indica-
tes display of accurate radio-controlled time. The digit to the right
of the radio tower, reception control, displays the number of days
the watch could not establish connection to DCF transmitter. "0"
means the best reception conditions. After 3 seconds the LCD dis-
play switches automatically back to display of the date.
10
Selection of time zone:
Use a spike-like object to actuate the corrector 1 (left dimple button)
for a short time (< 3 seconds). The LCD displays the current time
now. Repeated short actuation of the corrector 1 advance the time
displayed on LCD by one hour each as if moving eastward through
the individual time zones. After each actuation of the button also
the hands of the watch advance by one hour. After the eleventh
actuation of the button you advance from the west (as if backwards)
towards the CET by one hour each. For Great Britain with minus one
hour as compared to DCF-time as extreme case, you have to actua-
te the button 23 times. In case of slow actuation of the compensa-
tor, hands of the watch follow each of these 23 changes. Your watch
did not fail if, in case of extremely fast sequence of these 23 actua-
tions, its hands perform only the 11
after the last actuation the LCD switches back to corrected time
zone display of the date.
Switching back to DCF-time: (from the set time zone)
Actuate the corrector 1 (left) for more than 3 seconds. Your watch will
be automatically reset to all current DCF-time information. Because
of the internal memory, this function is available at any time during
or after long-range travels, even out of the range of transmitter.
Note: Manually activated transmitter call (following section) and
automatic reception (transmitter tower is blinking) will be perfor-
med only if no other time zones were programmed as DCF-time plus
/ minus one hour. This restriction protects your battery.
th change of time. 9 seconds
11