Ferroli TERMO MODENA Installations-, Bedienungs- Und Wartungsanleitung Seite 40

Menu 02 – set clock
4.6.1
Before operating with the stove the current time and date must be set in order to have a reference for possible
chrono programming.
The electronic control has a 3-volt lithium battery model CR2032 that gives the internal clock with own autonomy of
more than 4-5 years; if the clock does not keep the time with stove not powered or a series of zeros appears at
restart, battery replacement is necessary: call an authorised service centre.
To set the clock, access the menu by pressing P3 and adjust the time with buttons P1 and P2. Press P3 again to
adjust the minutes, day, month and year.
Menu 03 – enable chrono
4.6.2
For enabling all chrono functions. To enable the chrono, access the first sub-menu ENABLE CHRONO and set it to
ON with buttons P1 or P2. The corresponding symbol lights up on the display and programming is active. The
manual controls of the panel and the remote control retain priority with programming.
Access the second sub-menu DAY PROGRAM to enable or disable the daily chrono with buttons P1 and P2. Then
press button P3 to set up to two operation phases delimited by the set times.
Access the third sub-menu WEEK PROGRAM to enable, disable and set the functions of the weekly chrono. Follow
the same procedures of the previous paragraph. Up to four operation phases delimited by the set times and days
can be set.
Do the programming carefully, without overlapping the activation and/or deactivation times on the same day in different
programs.
Access the fourth sub-men WEEKEND PROGRAM to enable, disable and set the chrono functions for the weekend.
Follow the same procedures of the previous paragraph. Up to two operation phases delimited by the set times can
be set.
To avoid unwanted startup and shutdown operations, activate only one program at a time.
Menu 04 – select language
4.6.3
With this selection it is possible to set the desired language from those available.
Menu 05 – standby mode
4.6.4
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature T has reached the set value (Tset + ΔT) for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees and precisely (Tset - ΔT) where ΔT default = 2°C.
With the OFF selection, the modulation function is active but not the STANDBY mode. Therefore when the
temperature exceeds the set value the stove will operate at minimum power.
If the installation involves the use of a hot water tank, the standby mode is restricted to ON, and cannot be disabled.
Menu 06 – buzzer
4.6.5
With this selection it is possible to activate or deactivate the stove alarm buzzer.
Menu 07 – initial loading
4.6.6
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P4.
Menu 08 – stove status
4.6.7
This selection is reserved exclusively for the authorised service centre technician.
Menu 09 – settings by technician
4.6.8
This selection is reserved exclusively for the authorized service centre technician.
Modification of the technical parameters of menu 09 must be done by an authorised and competent technician; any
modifications made randomly can cause serious damage for which the constructor declines any liability.
Menu 10 – settings by installer
4.6.9
This selection is reserved exclusively for the authorised service centre technician.
4.6.10 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.
40
TERMO MODENA