TFA ECO SOLAR 30.2026 Bedienungsanleitung Seite 6

TFA_No. 30.2026_Anleitung_08/10
AVENUE – Garden thermometer with solar lighting
Functions
• Clear functional design
• Large digital display with 3 different modes:
1. Current temperature
2. Current temperature and clock in sequence
3. Current, highest and lowest temperature and time in sequence
• Maximum and minimum values with auto reset
• Automatic backlight at dark
• Rod (separable) in aluminium
• For putting in the ground
• Solar panel - 180° rotatable
• Weather resistant
Display (Fig. 1)
A: Battery symbol
B: Indication time/temperature
C: Symbol Daylight Saving Time (DST)
D: Automatic reset (Auto Reset)
E: Display mode A, B or C
F: PM at 12-hours system
G: Symbol maximum temperature
H: Symbol minimum temperature
Buttons (Fig. 2)
I: MODE button
J: +1 button
K: Switch A-B-C
L: +/- 1Hr button
M: ECO slide
Housing (Fig. 1+2)
N: Battery compartment
O: Temperature probe
P: Solar panel
10
02.08.2010 11:16 Uhr Seite 6
AVENUE – Garden thermometer with solar lighting
Getting started
• Open the battery compartment by a screw driver.
• Insert the batteries (above: rechargeable battery 1 x 1,2 V AA for the illumination;
down: battery 1 x 1,5 V AA for all functions) into the battery compartment, observ-
ing the correct polarity.
• ATTENTION: The 1.2 V rechargeable battery for the backlight is not fully charged
when shipped. For maximum efficiency it is advisable to have the rechargeable
battery fully charged by the solar panel on a sunny day before the first use. Alter-
natively, the rechargeable battery can be recharged with an ordinary battery
charger.
• Pull off the protection foil on the display.
• The unit is now ready to use.
• All LCD segments will light up for about a few seconds
• 00:00 appears on the display and the DST symbol
• Do we have Daylight Saving Time, press +/-1Hr button for confirmation while the
symbol is flashing and the DST symbol
• During standard time press +/-1Hr button once again and the DST symbol
appears.
• Is there no confirmation within 15 seconds the DST symbol
disappears.
• For a simple time switch with only one keypress you have to have a correct setting
(see point: Daylight Saving Time / Standard Time switch)
• The buttons are located inside the battery compartment.
Manual setting of clock
• Slide the switch to position B or C.
• As soon as the time appears in the display press MODE button to enter the setting mode.
• The hour digit is flashing.
• Press +1 button to set the hours. Hold and press the button for a fast count.
• Press MODE button again and set minutes in the same way.
• Press MODE button again and you will return to normal mode.
• The instrument will quit the setting mode, if there is no button used within
15 seconds period.
is flashing.
remains on the display.
dis-
stops flashing and
11