Chicco Pappacalda Bedienungsanleitung Seite 9

cian or one of Artsana S.p.A.'s authorised retailers.
• Incorrect repairs carried out by unqualifi ed technicians may cause damage or injuries to the user.
• Dispose of any packaging, worn accessories, and/or the equipment at an appropriate differentiated
collection point, as required by the regulations in force in each country.
This product is approved to EU 2002/96/EC Regulation.
The crossed bin symbol shown on the equipment indicates that, at the end of its useful
life, the product must be treated separately from domestic waste and disposed of at an
appropriate differentiated collection point for electrical or electronic equipment, or de-
livered to the retailer at the time of purchase of new, equivalent equipment. The user is responsible
for disposing of, or delivering, the worn or damaged equipment to the appropriate collection points.
The appropriate differentiated collection and subsequent recycling or treatment of the equipment
disposed of, in compliance with environmental laws, helps to avoid possible negative effects on health
and on the environment, and favours the recycling of the materials that the product is made of. For
further information on the collection systems available, please contact your local waste disposal
service, or your retailer.
IV. INSTRUCTIONS FOR USE
How to Prepare the Equipment:
Always ensure that the power cable's plug is disconnected from the mains socket. Pour some water
into the heating chamber of the feeding bottle warmer, ensuring that it does not exceed the maxi-
mum level (approximately 140ml) indicated by the two highest notches, located inside the chamber.
Slowly insert the feeding bottle/baby food jar inside the chamber, making sure that the heating water
does not spill out of the top of the equipment, and that it does not reach the upper rim of feeding
bottles and/or baby food jars.
Warning: Never operate the equipment without water inside the chamber, or if the quantity of water
is below the minimum level (approximately 70ml) indicated by the two lowest notches, located inside
the chamber.
HOW TO WARM UP FEEDING BOTTLES
• After preparing the feeding bottle warmer as described in the paragraph above, place the feeding
bottle warmer on a fl at, stable surface and connect the plug to a mains socket.
• Select the feeding bottle warming mode, positioning the lever of the selector to the left, pointing
to the icon "feeding bottle". The red warning light will indicate that the equipment is warming up
the feeding bottle.
• After a few minutes* of operation, the green warning light will switch on, and two short beeps will
indicate the end of the warming up cycle.
* The heating time can vary a lot, depending on the type/size of the feeding bottle, and the type,
quantity and initial temperature of the food inside the feeding bottle.
• To switch off the feeding bottle warmer at any time, move the cursor to the central position, and
disconnect the power cable's plug from the mains socket.
• Warning! Before feeding baby, it is recommended to:
• a) Dry the feeding bottle thoroughly.
• b) Shake the feeding bottle for a few seconds in order to homogenise the temperature of the food inside.
• c) Always check that the temperature of the food is not too hot before feeding baby (by pouring a
few drops of liquid on the inner of part your wrist).
9