Turning On The Clearreader; Standby Mode; Turning Off The Clearreader - Optelec ClearReader+ Bedienungsanleitung

+
Optelec ClearReader
+

Turning on the ClearReader

+
To turn on the ClearReader , press the round Power button on
the right-hand side. The start-up process will take approximately
40 seconds. You will hear a series of beeps to indicate that the
+
ClearReader is starting up followed by the start-up sound. Now
+
the Power indicator is lid up and the ClearReader is ready to
use.

Standby mode

+
The ClearReader will go into standby mode if no button is
pressed for 15 minutes on batteries and 30 minutes if connected to mains power. The standby
+
sound will be played, the Power indicator will start blinking and the ClearReader will go into
+
standby mode. To wake up the ClearReader from standby, press the Power button. When the
+
batteries are fully charged, the standby time of the ClearReader is approximately 40 hours.
+ +
After 40 hours the ClearReader will power down. If switching-on the ClearReader from the
standby mode, the start-up process will take approximately 10 seconds.
+

Turning off the ClearReader

+
Press the Power button to power down the ClearReader completely. The power down sound
will be played and the Power indicator will turn off.
English Page 13