ASROCK H67M-GE Handbuch Seite 22

2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors
(SATA2_2: see p.2, No. 14)
(SATA2_3: see p.2, No. 15)
(SATA2_4: see p.2, No. 16)
Serial ATA3 Connectors
(SATA3_0: see p.2, No. 10)
(SATA3_1: see p.2, No. 9)
Serial ATA (SATA)
Data Cable
(Optional)
22
These three Serial ATAII
SATA2_2
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATA2_3
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATA2_4
These two Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
ASRock H67M-GE Motherboard
the red-striped side to Pin1