Program Settings; Technical Data; Dip Switch; Technical Specifications - Nibe EME 20 Installateurhandbuch

Program settings

Dip switch

The DIP switch (S2) on the communication board (AA23).
Default OFF.
ON
1 2 3 4
Program settings
Program setting for EME 20 can be performed via the
start guide or directly in the menu system in NIBE heat
pump/indoor module/control module.
TIP
Also, see the Installer Manual for the heat
pump/indoor module/control module.
Start guide
The start guide appears upon first start-up after installa-
tion of the heat pump/indoor module/control module,
but is also found in menu 5.7.
Menu system
If you do not make all settings via the start guide or need
to change any of the settings, this can be done in the
menu system.
Menu 5.2.4 – accessories
Activating/deactivating of accessories.
Select: photovoltaic control
Menu 4.1.10 – solar electricity
Here you set whether you want EME 20 to affect the
room temperature and / or the hot water and / or pool.
affect room temperature
Setting range: on/off
Factory setting: off
affect hot water
Setting range: on/off
Factory setting: off
affect pool
Setting range: on/off
Factory setting: off
12
6 7 8
5

Technical data

Technical specifications

EME 20
External; dimen- mm
sions (LxWxH)
Enclosure class
Part no.
81x81x28
IP22
057 188
EME 20 | GB