Faults And Corrective Actions - Lanaform Vapo 360 Gebrauchsanweisung

To clean the reservoir:
1) Clean the reservoir using a soft cloth, together with some vinegar if there is any scale or calcium deposits inside;
2) If the scale covers the safety switch, place a few drops of vinegar on it and clean it with a soft brush;
3) Rinse out the reservoir with fresh water.
Storage:
1) Clean and dry the ultrasonic humidifier carefully.
2) Allow it to dry completely before putting the unit away. Do not store the unit with water still remaining in the base
unit.
3) Store the unit in a cool, dry place, out of the reach of children.

Faults and corrective actions

Should a fault occur during normal use, please consult the table below:
Fault Possible causes
No power.
Unit does not blow, no
Main power switch off.
mist
The water level is too high.
Leak from water reservoir
No water in the reservoir.
The water level detector is not in
Unit blows, but no mist the right position.
The temperature of the unit is
too low.
The water has been standing too
long in the reservoir.
Mist has a strange smell
The unit is new.
The mist power level is set to
minimum.
Deposits on the transducer.
Low power
The water is too cold.
The water is not clean.
The mist power level is set to
minimum.
The reservoir and the base unit
The mist does not rise
are not perfectly seated.
The fan unit is not functioning
correctly.
Corrective action
The device is not plugged in correctly or your power
supply is defective
Switch on the main power switch.
Remove some water.
Close the lid correctly.
Fill the reservoir.
Position the water level detector correctly.
Place the unit in a room at ambient temperature for
half an hour before use.
Clean out the reservoir and add fresh water.
Open the water reservoir and ventilate for 12 hours in
a cool room.
Adjust the control button to the correct setting.
Clean the transducer.
Use water at a normal temperature.
Clean out the reservoir and add fresh water.
Adjust the control button.
Check for correct seating
Ask a specialist to check the fan in the base unit.
Vapo 360°
EN
7