Installation Instructions - Lanaform Vapo 360 Gebrauchsanweisung

INSTRUCTIONS FOR USE
Characteristics:
• Generates anions.
• Water reservoir with a 3.5 litre capacity.
• Up to 10 hours continuous operation.
• Novel design with compact and attractive shape.
• Very quiet in operation due to special configuration (<35Db). The humidifier is especially suitable for children's and old
people's rooms.
• The steam nozzle broadcaster pivots through 360° which ensures an even distribution of the humidity throughout the
room. The quantity of mist may be adjusted as required.
• Equipped with a negative ions generator.
• Water softener: the humidifier is fitted with a water softener that reduces scale formation.
• Energy saving: it only consumes 35W of electrical power.
• Safe and reliable.
• An automatic device shuts down the unit if the reservoir is empty.
• With remote control.
• Increases and controls the relative humidity in the room
• Eliminates electrostatic charges
• Help to improves ambient air quality
• Help to maintains good health and protects the skin
• Help to controls room temperature.
Instructions:

Installation instructions:

1. Place the unit on a solid, level surface. The humidifier must remain horizontal and not move about.
2. The humidifier must not be positioned close to a source of heat (cooker or open fire) and must not be exposed to direct
sunlight. Keep it away from furniture and electrical equipment.
3. The mist generated by the humidifier must not be pointed directly at furniture or electrical equipment since they may
be damaged by the humidity.
Instructions for use:
1. The operating environment for the humidifier is a temperature ranging from 5 to 40 °C, with a relative humidity of less
than 50 % RH.
2. Use only boiled and cooled water (demineralised tap water) or distilled water for each use. Use clean water at a
temperature of less than 40 °C.
Operating sequence
1. Remove the steam nozzle broadcaster, withdraw the water reservoir and remove its cap. Fill the reservoir using
demineralised tap water with a temperature of less than 40°C or distilled water. Screw the cap back on the reservoir
and replace it in the main housing. Put the steam nozzle broadcaster back in position.
2.Connect the unit to a 220V/50Hz power supply.
3. Push the On/Off button. The indicator lamp lights up to show that the unit is operating. Within one or two minutes it
starts to generate mist. You can adjust the quantity of mist to your own requirements (up to the maximum setting).
Vapo 360°
EN
5