Rolls ISTBJV01 Handbuch Seite 25

PROFESSIONAL LEARNING PROCEDURE
Using this procedure the installer can determine the instant in which deceleration begins and the back jump type.
Put the door in an
1.
intermediate position.
Yellow led is off
6. Press the push button
P1/SET or the start key of the
radio control.
Yellow LED stays on
7. The control unit
performs
the opening
Yellow LED stays on
When you want to start
12a.
the slow-down, press the
start key of a radio control
or the push button P1/SET
14a. Press button
START
Yellow LED turns off
Press and hold
2.
the programming button
P1/SET for 2 sec.
Yellow led flashes
5. The door close until
mechanical stop
Yellow LED stays on
Do you want
8.
deceleration during
opening?
YES
When you want to start
9a.
the slow-down, press the
start key of a radio control
or the push button P1/SET
Do you want
11.
YES
deceleration during
closing?
12b. Mechanical stop
intervenes. End of closing
Yellow LED stays on
NO
13. Do you
want back jump
function? *
Yellow LED stays on
Press button
14b.
SET o r wait
8 seconds
Yellow LED turns off
Within 5 seconds, press
3.
the programming button
P2/RAD for 1 sec.
Yellow LED turned on
4.
Yellow LED stays on
NO
9b.
Yellow LED stays on
10. Press the push button
P1/SET or the start key of the
Yellow LED stays on
* back jump= short reverse gear
at the end of the complete closing
to loosen the mechanism and
SHORT
14c.
Yellow LED turns off
LONG
The control unit
briefly open
Mechanical stop
intervenes.
End of opening
radio control.
facilitate the release
Press button
RADIO
GB
24