Manual Manoeuvre; Operation - Rolls ISTBJV01 Handbuch

FIXING THE DOOR TO THE BRACKET
Set the automation to manual operation (fig.20), and then drag the carriage to the door. Fix the bracket (Q) to the door making
sure the two surfaces mate perfectly (fig.17).
Please verify it is firmly fastened, opening and closing the door manually.
!
ADJUSTING THE END OF STROKE
With the automation set on manual operation, fully close the door, loosen the catch screw (R) and join the catch itself to the drive
carriage. Then tighten the screw (R) firmly (fig.18).
Repeat the operation with the door fully open (fig.19).
The release manoeuvre has been provided for manual opening of the door in case of a power cut or motor breakdown.
In order to enable all types of use (for example the presence of an electric or outside lock) the handle has been designed to lock
itself perpendicularly to the carriage, allowing the user to completely do away with door automation.
The gear motor can also be released from the outside installing the optional accessory "SBLO01".
The two manual operating modes are:
MODE 01:
If you would like to release the
automation and keep it released
even after closing the gate.
MODE 02:
If you would like to release the
automation and then re-activate it
during the manual closing, thus
blocking the gate.
During manual operation use only the door for opening and closing, thus avoiding strain on the carriage by pulling
!
the release cord.

MANUAL MANOEUVRE

OPERATION:

The user that exits from the garage
can close the gate and re-enter
without having to repeat the release
operation. The automation release
must be guaranteed by an external
blocking system (a lock, for
example)
OPERATION:
The user that exits the garage,
making use of the reconnection of
the automation during the manual
closing operation, obtains the
recoupling of the carriages and thus
the blocking of the gate
20
INSTRUCTIONS:
- Pull the release cord downwards
as illustrated in figure 20 until the
handle perpendicular to the guide
is blocked, unhooking the lower
driving carriage.
- Move the gate manually
INSTRUCTIONS:
- Pull the release cord downwards
as illustrated in figure 20 until the
handle perpendicular to the guide
is blocked
- Move the door manually
- Return the handle to the original
position (fig. 21 - 21b)
21
GB
21b
20