Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
k
⑫
In this view, new number plates can be added to create or com-
plement a list To do so, click
corresponding data (number plate, list type "White List" or "Black
List", validity period) Click ✔ to save the entries made in this line
or ✖ to cancel At the end of their validity period, entries will be
automatically removed from the list
The list of number plates can also be created externally as a
table with up to 1001 entries, e g with Microsoft Excel To get
the required table format, it is recommended to start by creating a
table with a few entries in this view, to export the table (
process it externally Then import the table to this view using
Note: Even though the name of the exported table is preset to "BlackListxls",
the table contains the number plates of both lists
Click "Advanced" underneath the table to go to the configuration
of actions to be performed when any number plate has been de-
tected ("All"), when the number plate detected is on the "Black
List" or "White List" or when the number plate is not on any list
("Not in List")
For additional settings of FTP, SMTP and for switching the alarm
output, go to the views "Network Service FTP", "Network Service
SMTP" and "License Plate Recognition Linkage Configure"
to add a new line and enter the
) and to
c
6.3.2 Parameter Configure
This view allows you to make the following settings:
Setting
Minimum Width of
minimum width of a number plate to be detected
License Plate (pixel)
(number of pixels)
Direction Angle of
correction value for the angle of view to the number
Vehicle
plate
In the default setting, the number plate recognition is made in the
entire image It can, however, be limited to a specific section of
the image: Drag the mouse to draw a rectangle over the desired
section of the image The corresponding section will be displayed
as a flashing green rectangle When you click this image section
with the right mouse button, the entire image will be used again
Click "Apply" to save this setting to the camera
6.3.3 Linkage Configure
This view allows you to make the following settings:
Setting
Close = relay contact will close after recognition
Valid Signal
Open = relay contact will open after recognition
Time of Duration
duration of relay action in seconds
FTP Upload
On/Off
Screenshots
Video Displaying
the number plate detected most recently is inserted
License Plate
in the image
Time of Duration
duration of insertion in seconds , 0 = always
(0 s : Continuous)
For additional settings regarding the way the number plate de-
tected most recently is inserted in the image, go to "LPR Info" in
the view "Device OSD"
Function
Function
17
Werbung
Inhaltsverzeichnis
