Technical Data - Beper BP.652 Betriebsanleitung

EN
Blender Use instructions
Product description Fig.1
1. Main unit
2. Detachable shaft
3. On/off and speed control button
4. Release shaft button
Operation:
• Remove the product from the packaging and check that it is intact and that all components are inside.
• Remove the product from the packaging and check that it is intact and that all components are inside.
• Carefully wash the product, as described in the appropriate "cleaning" section.
• Connect the shaft to the main unit
• Insert the plug in the socket, making sure that the wire is not dimmed and / or close to heat sources.
• Insert the shaft into the container with the food previously cut and which is recommended to have added liquid
(water, milk, broth). Do not operate the appliance with solid foods only.
• Use a container large enough so that no sketches come out.
• Activate the product by pressing on the on/off and speed control button placed on the handle. As much you will
press on the button, as much will increase the working speed of the blender.
• Disconnect the appliance from the power outlet after use.
• Disconnect the shaft from the main unit, by pressing the release button placed on the bottom part of the handle.
• Wash the appliance as indicated in the "Cleaning" section.
CLEANING:
Always switch off the appliance and disconnect the power cord from the electrical outlet.
Clean the main unit with a damp cloth, do not immerse it in water or other liquids and do not wash it in the di-
shwasher or under the tap.
Wash the shaft with warm water and detergent.
PAY GREAT ATTENTION WHEN WASHING STEEL BLADES, THEY ARE SHARP AND CAN HURT .
Do not use metal brush or other abrasives on plastic or metal parts.
Do not try to sharpen the blades.
Before storing the appliance, make sure it is completely dry.

TECHNICAL DATA:

Power: 800W
Power supply: 220-240V~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9