Fixing The Control Panel; Speaker With Microphone Assembly; Removing The Bluetooth® Control Panel; From The Helmet - Cellular Line INTERPHONE F3 Bedienungsanleitungen

onto the helmet, take great care with its positioning, when
applying.

FIXING THE CONTROL PaNEL (9)

After having assembled the support onto the helmet, take
the Bluetooth® control panel, and insert into the guide, from
top to bottom.
Check that the Bluetooth® control panel is correctly locked in
its casing by trying to remove it, pulling upwards.
The control panel must always be inserted from top to bottom,
regardless of whether the kit is positioned to the right or left
of the helmet. The connector for the speaker with microphone
must always be beneath the Bluetooth® control panel.

SPEakER WITH MICROPHONE aSSEMbLY (10)

Take the piece of Velcro and apply to the inside of the helmet
with the bi-adhesive, positioning it at your ear.
N.B.: before positioning the Velcro, it is a good idea to try it out. Put the
helmet on and check the most suitable position for fixing.
Apply the speaker with microphone to the Velcro you have
just installed in the helmet.
Connect the speaker with microphone connector to the so-
cket on the Bluetooth® control panel (the connector can only
be inserted in one position).
Any excess wire must be gathered up into the helmet, be-
neath the padding.
REMOvING THE bLUETOOTH® CONTROL PaNEL FROM
THE HELMET
To remove the Bluetooth® control panel, press the locking
lever against the helmet shell and, keeping it pressed, allow
the Bluetooth® control panel to slide upwards.

1.3 Turning on / Turning off

TURNING ON
Press and hold the MFB button for approximately 3 seconds.
The speaker will sound an acoustic warning and the LEDs will
begin flashing quickly for around 3 seconds.
Subsequently, in stand-by mode, the LED will flash approxi-
mately once every 5 seconds.
24
TURNING OFF
Press and hold the MFB button. The speaker will sound a
prolonged acoustic warning and the LED will flash red prior
to turning off.

2 PaIRING

2.1 Telephone

Pairing
INTERPHONE F3 can be used with a mobile telephone.
After having turned INTERPHONE F3 off, press and hold the
MFB button until the warning light alternates red and blue
flashes. This will take about 8 seconds.
When the light is flashing red/blue alternately your INTER-
PHONE F3 is in pairing mode, go to the Bluetooth menu in
your telephone and select search for devices (please refer to
the telephone or navigator manual).
The telephone or navigator will detect INTERPHONE F3.
Simply select it, and enter the numerical code 0000.
To use with a mobile telephone and GPS navigator at the
same time, see point 2.4.

2.2 Intercom

Pairing
After having turned the two INTERPHONE F3s off, press and
hold the MFB buttons on both until the warning light alter-
nates red and blue flashes. This will take about 8 seconds.
When both LEDs flash red/blue alternately, press and release
the MFB button on one of the two INTERPHONE F3s.
The two INTERPHONE F3s are connected when both LEDs
show a fixed blue light.
NOTE ON COMPATIBILITY WITH OTHER INTERPHONE MODELS
The INTERPHONE F3 intercom connection is also compatible with pre-
vious INTERPHONEF4/INTERPHONE Cellular Line® devices.
Pairing: press and hold the MFB buttons on both until the
warning light alternates red and blue flashes. For INTER-
PHONE F3/F4 this will take about 8 seconds, for INTERPHO-
NE, about 5 seconds.
When both devices flash red/blue alternately, press and rele-
ase the INTERPHONE F3 multipurpose button (the red and
blue LED will flash more quickly).
Wait a few seconds, and when the devices are connected,