Inhaltsverzeichnis
Werbung
AXIS Q1615-E Mk II Network Camera
Hardware Overview
1
Cable gland
2
Gasket
3
Cable hole
4
Cable gland
5
Network cable (route through wall bracket)
6
Bottom cover
7
Bottom cover screws (4x)
8
Wall mount
9
Bracket adjustment screw
Connectors and Buttons
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE
NO
NO
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices
are installed in accordance with the manufacturer's instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
•
Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
8
Werbung
Inhaltsverzeichnis
