Team RC 5 Bedienungsanleitung Seite 16

Fax +32 2 359 95 50

d) Citrus press set
 Make sure the appliance is unplugged, that the ON/OFF & speed switch (6) is in "0"
position and that the safety lid (20) is closed.
 Place the processor bowl (10) onto the shaft (fig. 2, page 6) and turn it clockwise until the
handle reaches the switch connector (8) (fig. 3, page 6).
 Place the support (18) on the shaft (9) (fig. 4, page 6).
 Place the strainer (22) on the bowl making sure its slot is in the direction of the bowl handle
(fig. 13, page 6).
 Put the cone (21) onto the shaft (fig. 14, page 6).
 Cut the fruits in two and press the fruit halves against the cone (inner side of the fruit on
the cone) (fig. 15, page 6).
 Plug in the appliance and turn the ON/OFF & speed switch to "1" to switch on the
appliance. For a punctual use, you can also use the pulse button (5), to do so turn the
ON/OFF & speed switch to "0".
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
 Be careful not to exceed the maximum level indicated on the bowl and unplug the
appliance after use.
e) Mixing with the blender
Before using the blender (3), the processor bowl (10) has to be fitted into the base and the lid
properly locked. Do not put any accessory or food into the bowl.
 Unscrew the safety lid (20) to remove it.
 Open the lid of the blender, put the ingredients for mixing into the blender and add the
liquid. IT IS VERY IMPORTANT that the mixture does not go above the maximum level
indicated on the blender jug (fig. 17, page 6).
 Place the blender jug (3) on its connector switch (4) (fig. 18, page 6) and turn it clockwise
until the handle is oriented to the left and the jug is properly fixed to the motor unit (fig. 19,
page 6).
 Shut the lid with its cap (1) and screw it onto the blender. Make sure the assembly has
been done properly (the lid and the bowl have to be locked).
 Depending on the type of food, you can prepare up to 1.5 l with the blender.
 Plug in the appliance and turn the ON/OFF & speed switch to the desired speed or use the
pulse button depending on the preparation.
 Never use the processor and the blender simultaneously.
 Once the mixing is done, turn the ON/OFF & speed switch to "0" and unplug the
appliance. Wait until the blender has come to a complete stop before removing the jug.
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
 Caution: your appliance is not designed to mix hot preparations and the plastic bowl
could break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the
whole cool down to a temperature lower than about 60°C (tepid preparation) before
pouring it into the plastic bowl. In case the lid would come up in spite of the precautions
mentioned in section « Important safeguards », you can also empty part of the
preparation and mix it in several times.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
16
Assembly page 16/64
special instruction from
TEAM RC 5 - 091211
Team