Team RC 2 Bedienungsanleitung Seite 15

Fax +32 2 359 95 50

Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min or xx is the maximum usage time). The
breaks should last at least 10 minutes. Any wrong use will invalidate the guarantee.
USE
To use the processor (B) the safety lid (1) must be locked into place. Also make sure the

appliance is unplugged, that the on/off & speed control switch is in "0" position.
 Place the processor bowl (13) onto the bowl shaft (7).
 Make sure the three tips around the bowl shaft are inserted into the three slots on the
bottom of the processor bowl.
 The bowl lid with funnel (12) must be locked into the bowl lid locking slot (6).
 Plug in the appliance
 Turn the ON/OFF & speed control switch (8) either to "I" (slow speed) or to "II" (fast speed),
depending on the preparation you make.
 You can also use the pulse button (10) but only if you turn the ON/OFF speed control
switch to "0". Press this button to use the appliance punctually. A light press will make the
motor work slowly, while a heavy press will make it work faster.
 You can also use the auto clean button (9) but only if you turn the ON/OFF speed control
switch to "0". With this function, the motor will only work slowly. This button is used to clean
the blender bowl (see the "Cleaning" section).
 Depending on the type of usage, different accessories should be used, according to the
below instructions.
FUNCTIONS
a) Grating / Slicing / Chipping
 Make sure the appliance is unplugged, that the on/off & speed control switch is in "0"
position and that the safety lid (1) is closed.
 Place the processor bowl onto the bowl shaft. Make sure the three tips around the bowl
shaft are inserted into the three slots on the bottom of the processor bowl.
 For grating, insert the spindle (14) into the centre of the reversible grating/slicing disk (15),
with the grating blade (16) side facing the lid with funnel (12). For that the three tips around
the spindle have to penetrate the three slots around the centre of the disk. Then rotate the
disk anti-clockwise by gripping the spindle as shown in the figure a and go as far as it can in
order to lock it into the disk.
 For slicing, the slicing blade (17) side must be facing the lid with funnel (12).
 For chipping, use the chipping disk (18) with the blade side facing the lid with funnel (12).
 Once mounted, place the disk on the bowl shaft and add the lid with funnel as described
in the section "Use".
 Cut the potatoes, carrots, cucumbers etc... into pieces and place the ingredients into the
funnel of the bowl lid.
 Use the pusher (11) to push food down the funnel. Never use your fingers or any other
utensil.
 Plug in the appliance and turn the ON/OFF & speed control switch to "I" (slow speed) to
start.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
15
Assembly page 15/40
special instruction from Team