Finding A Passage Within A Track - Philips AZ 1040 Handbuch

AZ 1040 /00 8
page
CD PLAYER
Playing a CD
1. Select CD source.
™
is displayed briefly.
2. Press OPEN•CLOSE to open the CD door.
™ Display:
3. Insert a CD or CD-R(W) with the printed side facing up and
press OPEN•CLOSE close the CD door.
™ Display:
flashes as the CD player scans the contents of
a CD. The total number of tracks and playing time are then
shown.
4. Press PLAY•PAUSE 2; to start playback.
™ Display: Current track number and elapsed playing time of the
track during CD playback.
5. To interrupt playback press PLAY•PAUSE 2;.
Press PLAY•PAUSE 2; again to resume play.
™ The display freezes and the elapsed playing time flashes when
playback is paused.
6. To stop CD playback, press STOP 9
Note: CD play will also stop when:
– the CD door is opened;
– the CD has reached the end
(unless you have selected REPEAT or REPEAT ALL);
– you select another source: TAPE / TUNER.
Selecting a different track
• Press SEARCH ∞ or § once or repeatedly until the desired
track number appears in the display.
• If you have selected a track number shortly after loading a CD or
in the PAUSE position, you will need to press
PLAY•PAUSE 2; to start playback.

Finding a passage within a track

1. Press and hold down on SEARCH ∞ or §.
™ The CD is played at high speed and low volume.
2. When you recognize the passage you want,
release SEARCH ∞ or §.
– Normal playback continues.
Note:
During a CD programme or if SHUFFLE/ REPEAT active, searching is
only possible within a track.
8
when you open the CD door.