Cassette Recorder; Playing A Cassette - Philips AZ 1040 Handbuch

AZ 1040 /00 10
page
CD PLAYER
Erasing a programme
You can erase the programme by:
– pressing STOP 9 once in the STOP position or twice during
playback. The display shows '
– pressing the CD door open;
– switching to TUNER/TAPE source.
CD player and CD handling
• The lens of the CD player should never be touched!
• If the CD player cannot read CDs correctly, use a commonly
available cleaning CD to clean the lens before taking the set to
repair. Other cleaning methods may destroy the lens.
• Sudden changes in the surrounding temperature can cause
condensation to cloud over on the lens of your CD player.
Playing a CD is then not possible. Do not attempt to clean the
lens but leave the set in a warm environment until the
moisture evaporates.
• Always keep the CD compartment closed to avoid dust on the
lens.
• To take a CD out of its box, press the centre spindle while
lifting the CD. Always pick up the CD by the edge and return
the CD to its box after use to avoid scratching and dust.
• To clean the CD, wipe in a straight line from the centre
towards the edge using a soft, lint-free cloth. Do not use
cleaning agents as they may damage the disc.
• Never write on a CD or attach any stickers to it.

PLAYING A CASSETTE

1. Select TAPE source.
™ The display shows
2. Press STOP•OPEN 9/ to open the cassette door.
3. Insert a recorded cassette and close the cassette door.
4. Press PLAY 1 to start playback.
5. To interrupt playback, press PAUSE ;. To resume, press the
key again.
6. By pressing SEARCH 5 or 6 fast winding of the tape is
possible in both directions.
7. To stop the tape, press STOP•OPEN 9/.
– The keys are automatically released at the end of the tape and
indication goes out, except if PAUSE ; has been
the
activated.
10
' briefly;
throughout tape operation.

CASSETTE RECORDER

X