Finding A Passage Within A Track - Philips AZ 1560 Handbuch

AZ 1560 /00
CD PLAYER
Playing a CD
1. Select CD source.
2. Press OPEN•CLOSE to open the CD door.
™ Display:
3. Insert a CD or CD-R(W) with the printed side facing up and
™ Display:
™ Display:
4. Press PLAY•PAUSE 2; to start playback.
™ Display: Current track number and elapsed playing time of the
5. To interrupt playback press PLAY•PAUSE 2;. Press
™ The display freezes and the elapsed playing time flashes when
6. To stop CD playback, press STOP 9.
Note: CD play will also stop when:
Selecting a different track
• Press SEARCH ∞ or § once or repeatedly until the desired
• If you have selected a track number shortly after loading a CD

Finding a passage within a track

1. Press and hold down on SEARCH ∞ or §.
– The CD is played at high speed and low volume.
2. When you recognize the passage you want,
– Normal playback continues.
Note: During a CD programme or if SHUFFLE/ REPEAT active,
8
Downloaded from www.Manualslib.com
8
page
when you open the CD door.
press OPEN•CLOSE to close the CD door.
as the CD player scans the contents of a CD.
The total number of tracks and playing time are then shown.
is shown if the CD R(W) is not finalised.
track during CD playback.
PLAY•PAUSE 2; again to resume play.
playback is paused.
– the CD door is opened;
– the CD has reached the end (unless you have selected
REPEAT ALL);
– you select another source: TAPE / TUNER.
track number appears in the display.
or in the PAUSE position, you will need to press
PLAY•PAUSE 2; to start playback.
release SEARCH ∞ or §.
searching is only possible within a track.
manuals search engine