Dometic CRE0050 Montage- Und Bedienungsanleitung Seite 20

Installing and connecting the refrigerator
7.2 Notes on installing the refrigerator
Observe the following when installing the refrigerator:
•
Install the refrigerator so that the warm air produced can easily escape
(either upwards or to the sides, fig. 5, page 4).
Key for fig. 5, page 4
No. Explanation
1 Cold intake air
2 Hot waste air
3 Condenser
4 Spacing above the refrigerator if there is not sufficient space for the air to
circulate above or at the side.
•
Observe the following installation dimensions:
– CRE0050: 550 x 390 x 544 mm
– CRE0065: 595 x 458 x 535 mm
– CRE0080: 578 x 485 x 650 mm
•
Keep objects clear of openings in the housing or installation structure (such as
ventilation slots, etc.).
•
Condensate is produced when the refrigerator is operating normally. You can
either wipe up the condensate on the floor of the refrigerator in regular intervals,
or drain it through an outlet in the floor of the refrigerator (see chapter "Mounting
the outlet port (optional)" on page 20).
7.3 Mounting the outlet port (optional)
➤ Connect a hose with an inside diameter of 10 mm (not included) to the outlet
port.
➤ Lay the refrigerator on its side in order to access the bottom side.
A
NOTICE!
Do not switch on the device until it stood in an upright position for a
period of 4 hours.
➤ Mount the outlet port (fig. 6 2, page 4) aligned to the front or to the back
according to the desired outlet direction.
➤ Remove the drain plug (fig. 6 1, page 4) inside the refrigerator.
20
CRE
EN