Preword; Presentation; Declaration Of Conformity; General Safety Rules - Autoadapt TURNIN Benutzerhandbuch

The contents of these instructions must be read and understood before the product is
taken into use. Keep the instructions easily accessible for further reference.
Turnin is a swivel base for car seats and has as such been safety tested. If the product
is altered or rebuilt for other purpose than intended Autoadapt AB denies all liability.
By any uncertainties or if faults should occur, please contact the workshop that has
installed Turnin or Autoadapt AB.
Installation and repair of the Turny must for safety reasons and for warranty conditions
be made by Autoadapt AB or by a workshop authorized by Autoadapt AB.

1. PRESENTATION

Turnin is a swivel base for turning the
car front seat inwards, allowing the
wheelchair occupant to move from
wheelchair to front seat. Turnin is suitable for MPV-
vehicles and Minibuses, where the user enters the
vehicle via ramp or wheelchair lift while seated in
the wheelchair.
Turnin is installed in combination with an optional
seat, preferably of a low-built type. In some vehicle
models the original car seat can be used.
The turning movement of Turnin is powered. The
lengthwise adjustment is manual.
Turnin is available in left side and right side ver-
sions.

2. GENERAL SAFETY RULES

Turnin is tested and approved for a total load of 150 kg, including seat.
Make sure no items of clothing gets caught in any equipment while turning the seat.

3. SPARE PARTS

Turnin has a CE-poster where the serial number is stated.
Please write this number below! The number is needed when ordering spare parts.
Serial nr: ______________________
6

DECLARATION OF CONFORMITY

Manufacturer: Autoadapt AB
Address: Hedeforsvägen 6, 443 61 Stenkullen, Sweden
Declares that the product TURNIN, model Right and Left
conformes to the following Directives and Standards:
72/245/EEC incl. 95/54/EC, 74/60/EEC incl. 2000/4/EC,
74/408/EEC incl. 98/37/EC, 89/392/EEC incl. 98/37/EC,
93/42/EEC and 95/28/EEC
ECE R-10, ECE R-17, EN 292-2/A1, EN 12182,
EN 60204-1, ICE 60068-2-1
ISO 3795, ISO 7637-1
FMVSS 201, FMVSS 207, FMVSS 208, FMVSS 209,
FMVSS 210, FMVSS 302
Stenkullen 2003-06-10
Håkan Sandberg
Managing Director, Autoadapt-BEV AB