Setting The Antenna Tuner; Tuning The Antenna - Feig Electronic OBID i-scan ID ISC.ANT800/600-DA Montage Und Installation

®
OBID i-scan

10.4 Setting the antenna tuner

The jumpers on the ID ISC.ANT800/600-DA antennas are factory set as shown below. The
settings should be verified for each antenna.
1Ω Q-resistance (jumpered)
2Ω Q-resistance
Antenna switch (jumpered)
Note: See also the installation guide for the ID ISC.DAT (M40401-xde-ID-B) dynamic antenna
tuner on the OBID i-scan® CD.

10.5 Tuning the antenna

To tune the antenna, open the ISOStart software and first read out the current Reader
configuration:
Step Procedure
Start ISOStart Software
1
Run „Detect" ...
2
...Follow the „New-File
3
Assistant" ...
...and read out the current
4
Reader configuration
FEIG ELECTRONIC GmbH
Installation
Table 5: Jumper settings on the tuner boards
Function
Page 30 of 38
Jumper Position
JP1 closed
JP2 open
JP3 closed
Note
ID ISC.ANT800/600-DA
M50101-0de-ID-B.doc