Application Tips - Bosch Gluey Originalbetriebsanleitung

16 | English
The ambient temperature and the workpieces to be glued
must not be colder than +5 °C and not warmer than +50 °C.
Materials that cool the adhesive down quickly should be
warmed first with a hot air gun.
Gluing (see image A)
To open the glue stick compartment, push the slider (5) in the
direction of ➊. Insert the glue stick (3) suited to the material
in the glue stick compartment (4) ➋.
Switch the glue pen on and allow it to heat up. The light-up
ring (6) will flash slowly.
As soon as the light-up ring (6) is continuously lit up, the glue
pen is ready to use.
Move the slider (5) in direction ➌ with moderate pressure to
deliver the adhesive. If the slider hits the front end, the glue
stick (3) has been used up. Insert a new glue stick.
Apply the adhesive to one side (see "Application tips",
page 16).
Press the materials you wish to glue together against each
other for around 10 to 30 seconds immediately after applying
the adhesive. Correcting the bonding location is still possible
at this point.
The bond is stable after approx. two minutes of cooling time.
Make sure you do not come into contact with the hot ad-
u
hesive. Use a silicone mat to press permeable materials to-
gether.

Application tips

Material/workpiece
Long workpieces with large
surface areas
Flexible materials (e.g. tex-
tiles)
Note: If a new glue stick is inserted, it will push the rest of the
previous glue stick out before the new colour or material
comes out. Please take note of this fact when changing the
colour or material of the glue stick.
Do not use flammable solvents to clean the bonding loc-
u
ations. The hot glue could ignite any solvent residue or re-
lease hazardous fumes.
Adhesive residue on clothing cannot be removed.
The bonding locations can be painted.
Errors – causes and corrective measures
Problem Cause
Glue pen does Zinc-carbon batter-
not work. ies (R6) used.
Glue pen only op- Alkali-manganese
erates for a short batteries (LR6) used.
time
Glue stick feed is Glue pen has not fin-
sluggish. ished heating up.
Feed is too fast
Batteries are weak
1 609 92A 4MF | (11.12.2018)
Recommendation
Apply adhesive in dots
Apply adhesive in lines
Corrective meas-
ure
Use NiMH batteries
(HR6).
Use NiMH batteries
(HR6).
Let the nozzle heat
up for 60 s.
Charge batteries
Bosch Power Tools