Ferax FKS-2000 Bedienungsanleitung Seite 9

19. Warning!
The use of any accessory or attachment, other
than those recommended in this instruction
manual, may present a risk of personal injury.
20. Have your tool repaired by a qualified person
This electric tool is in accordance with the
relevant safety requirements. Repairs should
only be carried out by qualified persons using
original spare parts, otherwise this may result in
considerable danger to the user.
Warning! Kickback may occur when the nose
or tip of the guide bar touches an object, or
when the wood closes in and pinches the
saw chain in the cut. Tip contact in some
cases may cause a lightning-fast reverse
action, kicking the guide bar rapidly back
towards the operator. Pinching the saw chain
along the top of the guide bar may push the
guide bar rapidly back towards the operator.
Either of these reactions may cause you to
lose control of the saw, which could result in
serious injury to the user. The following
precautions should be followed to minimize
kickback.
21. Guard against Kickback
A. Grip saw firmly! Hold the chain saw firmly with
both hands when the motor is running. Keep a
good firm grip on the saw with both hands, the
right hand on the rear handle, and the left
hand on the front handle.
B. Do not over reach.
C. Keep proper footing and balance at all times.
D. Do not let the nose of the guide bar contact a
log, branch, ground or other obstruction.
E. Do not cut above shoulder height.
F. Use devices, such as low-kickback chain,
guide bar nose guards, chain brakes and
special guide bars, which reduce the risks
associated with kickback.
G. Use only replacement bars and chains
specified by the manufacturer or the
equivalent.
H. There are no other replacement components
for achieving kickback protection in
accordance with CSA Z62.3.
22. Power supply
Connect the chain saw to correct voltage; be
sure that the voltage supplied is the same as that
specified on the nameplate of the tool.
23. Do not operate a chain saw that is damaged,
improperly adjusted, or not completely and
securely assembled. Be sure that the saw chain
stops moving when the trigger is released.
24. Do not attempt operations beyond your capacity or
experience.
25. Do not operate a chain saw with one hand!
Serious injury to the operator, helpers, or
bystanders may result from one-handed
operation. A chain saw is intended for two-handed
use.
26. To reduce potential for electric shock, do not
operate the saw on wet or slippery surfaces,
or during snow storms, rain storms, and other
adverse weather conditions.
27. Keep the handles dry, clean, and free of oil or
grease.
28. Do not allow dirt, debris or sawdust to build up on
the motor or outside air vents.
29. Follow the manufacturer's sharpening and
maintenance instructions for the saw chain, how to
sharpen the saw.
30. Cut at high motor speeds.
31. Operation of a chain saw should be restricted to
mature, properly instructed individuals.
32. Your chain saw is intended for occasional
homeowner use. It is not made for heavy
continuous use.
33. Do not force a small saw to do a job requiring a
heavier duty unit.
34. Examine the electrical switches. Do not use the
chain saw if the switches do not properly turn on
and off. Do not attempt to make any repairs to
the electric switches. Take your saw to a Ferax
Authorized Service Center.
35. Maintain extension cords. Inspect the extension
cords periodically and replace if damaged. Only
use power cords that are suitably marked for
outdoor use (wiring ≥ 1,5 mm2).
36. Do not operate your chain saw near or around
flammable liquids or gases, whether in or out of
doors. An explosion and/or fire may result.
37. All chain saw service, other than the items listed
in the user manual safety and maintenance
instructions should be performed by competent
chain saw personnel. Do not attempt to repair
it yourself; there are no user serviceable parts
inside.
38. Never remove, modify or make inoperative any
safety device furnished with your unit. The Chain
Brake®/Hand Guard is a major safety feature. The
saw will not run when the Chain Brake® is tripped.
39. It is intended for infrequent use by homeowner's,
cottagers and campers, and for such general
applications such as clearing, pruning, cutting
firewood, etc. It is not intended for prolonged use.
If the intended use involves prolonged periods of
operation, this may cause circulatory problems
in the user's hands due to vibration. It may be
appropriate to use a saw having an anti-vibration
feature.
40. Safety clothing required by your safety
organizations, government regulations, or your
employer should be used; otherwise, snug fitting
clothing, safety footwear, and hand and ear
protection should be worn.
41. When felling, keep at least 2 tree lengths between
yourself and your fellow workers.
42. Keep everyone, especially children and pets,
away from the area of operation. Never allow
children to operate the appliance. Turn off unit
immediately if you are approached.
43. Avoid sawing in the soil, in fences and in wiring.
The chain saw also is not developed to saw
young/thin trees and prepared balks.
GB
9