ROBBE Futaba R 6007 SP Bedienungsanleitung Seite 13

Receiver installation
When installing the receiver please observe the
separate tips on receiver installation, to ensure that
you obtain optimum reception in all flight attitudes.
Receiver connections
Since the R6007 SP receiver outputs all seven
channels serially, the servo connections are arran-
ged slightly differently from usual.
In contrast to other Futaba receivers, only one lead
is required for signal transfer. This lead is used, for
example, by the HC3-Xtreme to assess the signals
and pass on the control information to the approp-
riate servos.
This feature makes it possible to minimise the wi-
ring in the model, which also helps to avoid excess
weight.
The arrangement is explained clearly in the examp-
le shown alongside (the channel assignment may
vary).
Note: Conventional servos must not be connected
directly!
© robbe Modellsport
Operating instructions R6007 SP 2.4 GHz receiver
3